PA D4000.4 PAD Series 4-Channel Amplifier - 400W When install space is at a premium, but your sound system demands plenty of power to realize its full potential, Polk Audio’s new super-efficient D Series amplifiers are a very cool solution.  Polk's PA D4000.4 4-channel amplifier may be small, but it can power your front and rear speakers with up to 125 watts RMS each.  Or, you can switch this little beast over to 2-channel mode to drive a couple subwoofers with up to 200 watts RMS each.  However you use it, this amplifier will fit in almost any location. Separate high- and low-pass filters on the front and rear channels allow this versatile amp to run a variety of speaker systems, like bi-amped mid-bass and tweeter components, or two front speakers and a sub. Features: * Super-Efficient Class D Bridgeable Design - Runs cooler than conventional amps.     * High-Speed MOSFET Switching power supply.  * Front and rear level controls. * Protection - thermal, DC offset, reverse polarity and short circuit. * Nickel-plated wire terminals and RCA connectors. * Stainless steel hardware. Technical Specifications: * Number of Channels - 4 * Frequency Response - 20Hz - 20KHz * 2 Ohm RMS Power (14.4V) Per Channel - 4 x 200W * 4 Ohm RMS Power (14.4V) Per Channel - 4 x 125W * 4 Ohm RMS Power Bridge (14.4V) Channel - 2 x 400W * Signal-to-Noise Ratio - >105dB * Product Dimensions (with panels) (H x W x D) -1.81'' x 10.94'' x 6.75'' *Sold as an Individual Warning [https://productimageserver.com/prop65/6pt.png]WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov [http://P65Warnings.ca.gov].